Free in-home measure and quote - PGT, CGI and CWS impact lines compared on your actual openings, style by style
Sliding glass doors
Impact garage doorsPGTCGI
Before
After
Before
After
Before
AfterFast, Reliable Window Replacement Across Eatonville
Window replacement in Eatonville, FL usually means one of two jobs: swapping rotted wood-framed originals for impact-rated units, or pulling out jalousie windows that Orange County code will no longer pass. A straightforward insert on a 1960s concrete-block home runs $600-$1,100 per opening. A full frame replacement with impact glazing runs $1,200-$2,400 per window. The work is rarely “just glass” here, and the quote you get should account for that from the first site visit. Call (813) 320-9346 and we’ll walk the house with you, measure every opening twice, and put the real numbers on paper before you commit to anything.
Why TruePane Windows & Doors Is Eatonville’s Preferred Window Replacement Company
We started working in Eatonville because the older housing stock here tells a story other towns don’t. Homes built between the 1940s and 1970s carry single-pane aluminum frames, jalousie louvers, and framing that was never flashed properly. Most window companies quote the glass and move on. That leaves a homeowner holding a permit rejection and a bigger bill than they planned. Our crews see those mid-century openings every week. We know what a 1962 wood-frame on Eaton Street hides behind the interior casing, and we write the allowance for it into the quote before the inspector ever shows up.
Eatonville is a small town. Word gets around. We earn bids here by doing the job once and standing behind it, which is why our customers in Eatonville tend to be people who have already been through one bad install and decided they’ll never repeat it. The 90-Day Done Right Promise applies on every job we finish here. So does The Keystone Standard: both manufacturer warranty layers registered in writing, with durations stated, before our truck leaves the driveway. That’s the difference between a receipt and an actual warranty.
Our team is led by Dale Kessler, a second-generation glazier who has been setting windows true since before most of our competitors were born. The founding rule is still on his whiteboard: if the pane is not true, the job is not done. That’s not a slogan. It’s how we run a site visit on Ivey Lane the same way we would on a million-dollar lakefront build.
Our Window Replacement Services in Eatonville
We don’t send a salesperson with a pitch book to your door. We send a glazier. The first visit is about finding out what’s actually in the wall, because in Eatonville, the wall usually has a say in what gets installed. Here’s what we handle:
Full Frame Replacement
Most Eatonville homes built before 1980 were framed for glass that doesn’t exist anymore. The rough openings are narrow, the jambs are soft, and there’s no sill pan or flashing tape anywhere. A full frame replacement means pulling the old window to the studs, rebuilding the opening square, flashing it properly, and setting the new unit true. In Eatonville, this is the service that most often starts as a “simple insert” and ends as the right call. We’ll show you why on the first visit, with the old window pulled and the rot visible, not described over the phone.
Insert Window Replacement
When the existing frames are sound and the openings are close to square, an insert replacement keeps the interior and exterior trim intact and drops a new unit into the existing line. This runs less than a full frame replacement and moves faster. In Eatonville, we see inserts work well on concrete-block homes where the rough opening is solid but the glass is single-pane aluminum from the 1970s. The catch is the wind-borne debris code. If the opening can’t accept an impact-rated insert without modification, you’re back to a full frame. We check that before we quote, not after.
Storm Window Replacement
Some Eatonville homes still run the old three-track storm window setups over original wood sashes. They rattle in July thunderstorms and do nothing for wind-driven rain. Replacing storm windows with a single impact-rated unit usually means rebuilding the exterior stop and re-flashing the perimeter. We treat this as a full frame job with a faster trim-out. You end up with one window that works instead of two that fight each other.
Energy-Efficient Upgrade
Central Florida UV is hard on glass and harder on window frames. Homes in Eatonville lose most of their cooling through single-pane aluminum windows and jalousies that seal only when they feel like it. A low-E, argon-filled insert or full frame replacement cuts that load immediately. Homeowners on Ivey Lane, Kennedy Boulevard, and the streets off Wymore typically see their July and August cooling bills drop 15-30% after replacing the worst rooms first. We’ll spec the glass per elevation: east and west openings get the highest solar heat gain rejection, north and south get lighter coatings so the rooms don’t go dark.
What happens when you call
- 1
A real person answersNo phone trees - you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Trusted Brands We Service in Eatonville
We’re an authorized installer for more than a dozen manufacturer lines, and we stock local parts for the brands Eatonville homes actually carry. Andersen, Pella, and Marvin all make units that hold up in Central Florida humidity when they’re set and flashed right. We quote manufacturer lines side by side on paper, so you see the glass package, the warranty duration, and the frame material in one place. No brand gets pushed because of a spiff. You get the unit that fits the opening and the budget we agreed on. See our full Window Replacement line card for what we service and install.
Common Window Replacement Problems We See in Eatonville Homes
- Jalousie windows seized open from pitted aluminum tracks. The crank assemblies on 1950s louvered glass were never built for forty years of Florida humidity. When they bind open, wind-driven rain walks in, and Orange County wind-borne debris inspections fail them on sight.
- Single-pane aluminum frames with worn weatherstripping condensing moisture inside walls. We open these up and find the wood jamb is not just damp; it’s been composting for years behind the casing. The interior side looks fine. The structural side is gone.
- Undersized rough openings in concrete-block homes. The original 1960s window cutout was framed for a thin aluminum unit. Modern impact-rated glass is deeper and heavier. A permit review will force the opening wider, which means a full frame replacement, not a slip-in insert.
- Missing flashing tape and sill pans on original windows. Decades-old installations were set against bare studs with no waterproofing. Water intrudes at the perimeter, mold grows behind the jamb, and the sash still works fine, so nobody notices until the wall stains through. That’s the quiet one.
Pricing for Window Replacement in Eatonville, FL
A typical insert window replacement in Eatonville runs $600 to $1,100 per opening for a standard double-hung or casement unit with low-E glass. Full frame replacement runs $1,200 to $2,400 per window, depending on the opening’s condition and whether we’re rebuilding a rotted jamb. Impact-rated glazing adds $150 to $400 per unit over standard glass, and in Eatonville, it’s usually mandatory, not optional. Historic wood window restoration on the town’s older contributing structures can run $1,800 to $3,500 per opening because the sashes are rebuilt, not swapped. We give written line-item quotes, the allowance for code-driven upgrades is in the contract on day one, and the price we agree on is the price you pay. Call (813) 320-9346 for a free estimate. Done right.
We Also Serve Cities Near Eatonville
Our crews work the full corridor around Window Replacement in Eatonville, including Acacia Villas, Alafaya, Altamonte Springs, and Altoona. If you’re a few minutes outside town, the same glaziers who know Eatonville’s jalousie-era stock will come out and measure yours.
Serving Eatonville, FL - Our Local Coverage Area
We’re based in the Eatonville area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
FAQs - Window Replacement in Eatonville
You can repair the crank and glass clips, but Orange County’s wind-borne debris zone code treats jalousie windows as non-compliant regardless of condition. No repair or reinforcement makes louvered glass pass inspection. A permitted replacement means impact-rated glazing or approved shutters. If you repair without a permit and the issue comes up at sale or after a storm, you’re the one holding the bill. Call (813) 320-9346 and we’ll show you exactly what the code requires for your house before you spend a dollar on repair parts.
Yes. Eatonville falls under Orange County permitting jurisdiction, and any window replacement that changes the structural opening or the glass type requires a permit and inspection. Even same-size inserts trigger the wind-borne debris review. We pull the permit, schedule the inspection, and stand there when the inspector arrives. You never chase paperwork on our jobs.
It means the seal between the two panes has failed, and the insulating gas has leaked out. The glass is dead. In Eatonville’s humidity, that fog becomes permanent condensation, and the window loses whatever energy performance it had. Once a seal fails, the fix is glass replacement or a full unit replacement, not a cleaning. Call (813) 320-9346 for a free look; we’ll tell you honestly if the sash is worth saving.
We cut out the rotted section back to sound wood, treat the remaining framing with a borate preservative, and rebuild the jamb with pressure-treated or composite lumber sized to the new unit. If the rot runs into the king stud or the sill plate, we bring in a carpenter to sister the framing before the window goes in. The repair is line-itemed and approved in writing before we touch it. No one finds out about a structural frame on the final bill.
Yes, and the drop is measurable the first summer month. Impact-rated units carry low-E coatings and insulated glass packages that single-pane aluminum and jalousie windows simply don’t have. Realistic expectations: 15-30% off the cooling portion of your bill if you replace the worst rooms first. The impact rating protects the house; the glass package is what lowers the bill. Call (813) 320-9346 and we’ll walk through which windows are costing you the most in July and August.
Written by Dale Kessler, Owner at TruePane Windows & Doors, serving Eatonville and Orange County.
Six Reasons Homeowners Choose TruePane Windows & Doors
Impact systems engineered to design pressures up to +/-100, matched to your wind zone - your openings hold when the storm arrives.
Low-E insulated impact glass from our manufacturer lines commonly cuts monthly cooling bills 20-30%.
Laminated impact glass shuts out up to 40% of outside noise - traffic, neighbors, weather.
Monitoring services run $30-90 a month. Laminated impact glass resists forced entry around the clock, with no subscription.
Florida homeowners average around 25% savings on the windstorm portion of their policy after protecting every opening - some homes qualify for more.
A full impact package upgrades curb appeal, buyer confidence and appraised value in one project.