Free in-home measure and quote - PGT, CGI and CWS impact lines compared on your actual openings, style by style
Sliding glass doors
Impact garage doorsPGTCGI
Before
After
Before
After
Before
AfterFast, Reliable Door Installation Across Kenwood Estates
Door installation in Kenwood Estates typically runs $900 to $3,400 depending on whether it’s a standard pre-hung replacement, Sliding & Patio Doors in Kenwood Estates, or a full masonry-opening rebuild that FBC wind-load compliance demands. Most homes here are single-story CBS construction from the late 1960s through the 1980s, and those original rough openings were never standard. That means a door that looks like a simple swap often isn’t. If the jamb is rotted, the rough opening is out of square, or the last installer set the slab into the old frame without measuring the block, you’ll feel it the first humid week. Our crews know Kenwood Estates openings because we’ve rebuilt enough of them to recognize the pattern before we touch a screw. Call (813) 320-9346 and we’ll come measure the masonry, not the old frame.
Why TruePane Windows & Doors Is Kenwood Estates’s Preferred Door Installation Company
We’re not the cheapest quote you’ll get for Door Installation. We’re the one that holds up after two storm seasons and a summer of ninety-percent humidity. Dale Kessler founded TruePane in 2008 on a rule that still governs every job: if the pane is not true, the job is not done. For a door, that means the slab sits square in a dry, properly flashed rough opening, and the stucco returns are sealed so wind-driven rain never finds the jamb.
In Kenwood Estates, our technicians see the same failure pattern over and over: aluminum frames oxidized from salt-laden air, wood jambs swollen and spongy from decades of moisture cycling, and hinge screws stripped out of rotted framing. We quote the repair the house actually needs, not the one that photographs best. Every estimate is written line-item, every warranty layer registered in writing before the truck leaves the driveway, and every job backed by our 90-Day Done Right Promise. That’s the Keystone Standard. It applies in Kenwood Estates the same as it did on our first job.
We’re not a franchise. We serve Kenwood Estates from our local crews, coordinated through our South Florida office. A live person answers the phone at (813) 320-9346, 24 hours a day. You call, a person picks up. That’s the deal.
Our Door Installation Services in Kenwood Estates
Entry & Swing Doors
Entry door replacement in Kenwood Estates almost always starts with the masonry opening, not the old frame. CBS homes from this era have rough openings that were formed around the block, not cut to a factory spec, so a standard pre-hung unit can bind within weeks. We measure the block opening, order the slab to fit, and re-frame with pressure-treated lumber where the original wood has turned soft. A properly set entry door in Kenwood Estates should close with one finger and stay square through August.
Storm Doors
Storm doors in Kenwood Estates do real work. They take the brunt of afternoon heat and the wind gusts that come off afternoon thunderstorms. A flimsy storm door with aluminum screws into a rotted jamb will sag by September. We set storm doors into fresh framing, use stainless hardware, and flash the opening so water that gets past the outer door doesn’t sit against the inner jamb. For older CBS homes, that detail is the difference between a door that lasts fifteen years and one that needs re-hanging every spring.
Arched & Custom Doors
Some Kenwood Estates homes were built with arched entryways or custom-height openings that don’t match anything in a supplier catalog. We saw this on a 1970s home off the main residential loop here. The original arched entry door had rotted through at the bottom rail, and the homeowners had been told twice that they’d need to square off the opening and lose the arch. We had the door made to match the existing radius, re-framed the rotted section, and kept the original look. That’s the difference between a company that works with custom manufacturers and one that only installs stock.
What happens when you call
- 1
A real person answersNo phone trees - you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Trusted Brands We Service in Kenwood Estates
We install and service doors from PGT, CGI, Andersen, and a dozen other lines, and we’ll put quotes side by side on paper so you can see exactly what you’re buying. For Kenwood Estates homeowners, we often recommend Impact Windows & Doors - Kenwood Estates from PGT or CGI because their wind-load documentation satisfies Florida Building Code requirements without changing the look of the original stucco entry. We register both warranty layers, manufacturer and workmanship, before the truck leaves your driveway. If you have an existing door from another brand, we service those too, and we keep common replacement hardware and weatherstripping on our trucks so one visit usually finishes the job.
Common Door Installation Problems We See in Kenwood Estates Homes
- Rotted rough openings from humidity cycling. The original wood jamb in a 1970s CBS home absorbs moisture from the block and the air, swells, then dries and cracks. By the time the door binds or the latch won’t catch, the wood behind the stucco is usually gone. We replace it with pressure-treated stock and flash it before the new jamb goes in.
- Dimensions taken from the old frame instead of the masonry. Installers who measure the existing door and order an identical replacement miss the fact that the opening itself was never square. The new slab goes in and binds within days. We measure the block opening itself, then order the slab to fit that.
- Missing flashing tape behind stucco repairs. Wind-driven rain in Kenwood Estates finds its way behind unflashed jambs fast. Once water gets behind the stucco return, the rotted wood that killed the original door comes right back. We wrap every rough opening in flashing tape before the new unit goes in, and we seal the stucco returns with a profile that sheds water, not traps it.
- Hinge screws stripping out of old wood. A heavy impact-rated door swinging on three short screws into thirty-year-old framing will eventually pull loose. We set hinges into solid blocking or use through-bolts with stainless hardware, whichever the opening requires. It’s a small detail that keeps a door plumb for decades.
Pricing for Door Installation in Kenwood Estates, FL
A standard single entry door replacement in Kenwood Estates runs $900 to $1,800 for a pre-hung unit set into a sound opening. Once you need masonry-opening measurement, re-framing, flashing, and stucco re-sealing, which most CBS homes here require, expect $2,200 to $3,400. Storm doors run $450 to $1,100 installed, depending on the existing frame condition. Arched and fully custom doors land between $3,000 and $6,500 based on the manufacturer and hardware. Energy-Efficient Windows - Kenwood Estates and impact-rated units from PGT or CGI add $800 to $1,800 over standard slabs, and we quote that difference plainly on paper before any work starts. Every quote is free. Call (813) 320-9346 and we’ll walk the job with you and put the numbers in writing.
We Also Serve Cities Near Kenwood Estates
TruePane crews work throughout the surrounding communities, including Acacia Villas, Alafaya, Altamonte Springs, and Altoona. Each area has its own housing stock and code requirements. The way we handle a 1970s CBS home near Kenwood Estates doesn’t change, but the permitting path does, and we pull permits through whichever jurisdiction governs the property. If you’re in one of those nearby cities and looking for Door Installation in Kenwood Estates standards applied to your home, call the same number: (813) 320-9346.
Serving Kenwood Estates, FL - Our Local Coverage Area
We’re based in the Kenwood Estates area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
FAQs - Door Installation in Kenwood Estates
Because the original rough openings in late-1960s through 1980s CBS homes were formed around concrete block, not cut to a factory spec, and the original wood jambs have spent fifty years absorbing moisture. An insert set into that compromised frame inherits the rot and the out-of-square condition. We tear out to the masonry, measure the actual opening, re-frame with pressure-treated lumber, flash it, and set the new door so it stays square. Call (813) 320-9346 for a free measurement and we’ll tell you whether your opening is a candidate for an insert or needs the full tear-out.
In Kenwood Estates, pulling a permit for an exterior door replacement means the new unit must meet current Florida Building Code wind-load requirements for the zone. On an older CBS home, that usually means an impact-rated slab or an assembly with documented storm protection, plus proper flashing and anchorage details the original never had. When we open the walls and find outdated or inadequate conditions, we price any required upgrades as a written change order before we do the work, never as a surprise on the final bill. Call (813) 320-9346 and we’ll walk you through what your specific opening will require.
We isolate the rot. On a 1970s CBS home in Kenwood Estates, we pulled an old entry door and found the original wood jamb so swollen from humidity cycling that the new slab wouldn’t sit square. We measured the masonry opening, re-framed with pressure-treated lumber, wrapped it in flashing tape, and set the new door without touching any surrounding structure. The scope stays on the door opening. If the rot extends into structural framing, we tell you before we cut, and we quote the additional framing as a separate line item, in writing, before we proceed. Call (813) 320-9346 for an assessment of your opening.
Yes. Manufacturers like PGT and CGI produce impact-rated slabs that fit standard and custom openings, and we can match the existing stucco texture and profile so the finished opening looks like it was always there. We’ve done this on arched entries, double doors, and single slabs. The stucco re-sealing after installation is part of the job, not an afterthought, and we match the original texture so the patch doesn’t read as a patch. Call (813) 320-9346 and we’ll bring samples and put the options on paper.
Because the screws were driven into thirty-year-old wood that had already begun to rot behind the stucco. A door that weighs eighty pounds pulling on three short screws into soft wood will loosen. We set hinges into solid blocking or through-bolt them with stainless hardware, so the hinge screws hold over decades instead of months. If your existing door is sagging at the hinges, call (813) 320-9346 and we’ll open it up and show you exactly what’s behind the plate.
Written by Dale Kessler, Owner at TruePane Windows & Doors, serving Kenwood Estates with door installation built on the Keystone Standard.
Six Reasons Homeowners Choose TruePane Windows & Doors
Impact systems engineered to design pressures up to +/-100, matched to your wind zone - your openings hold when the storm arrives.
Low-E insulated impact glass from our manufacturer lines commonly cuts monthly cooling bills 20-30%.
Laminated impact glass shuts out up to 40% of outside noise - traffic, neighbors, weather.
Monitoring services run $30-90 a month. Laminated impact glass resists forced entry around the clock, with no subscription.
Florida homeowners average around 25% savings on the windstorm portion of their policy after protecting every opening - some homes qualify for more.
A full impact package upgrades curb appeal, buyer confidence and appraised value in one project.