Window Replacement in Taft - Free In-Home Measure, Written Price

Fast, Reliable Window Replacement Across Taft

Window replacement in Taft usually runs between $450 and $1,400 per opening for a standard vinyl or aluminum retrofit, and a full-frame replacement with code-required upgrades lands between $900 and $2,200 per window. Most Taft homes we work on were built between the 1950s and 1970s, and many still carry original single-pane aluminum sliders or jalousie units that cannot meet Florida Energy Code today. That means the job is rarely just swapping glass. It means pulling permits, upgrading to low-E insulated glass, and often rebuilding the opening itself. Call (813) 320-9346 for a free estimate, and we’ll walk the house with you before you commit to anything.

Call (813) 320-9346

Why TruePane Windows & Doors Is Taft’s Preferred Window Replacement Company

We’ve spent more than years in Florida window and door work, and Taft’s housing stock is the kind we know best: modest CBS block homes from the post-war decades, built well but built for a different climate code. Dale Kessler founded TruePane in 2008 on a rule that still hangs in our shop: if the pane is not true, the job is not done. That standard carries to every opening we set in Taft, from a simple bedroom insert to a full-frame rebuild on a jalousie wall.

Homeowners in Taft call us because the alternative has burned them before. A 1990s retrofit that fogged between the panes within ten years. A contractor who never pulled the Orange County permit and left them holding the paperwork. Our crews are background-checked and uniformed, and we register both warranty layers in writing before the truck leaves the driveway. That’s The Keystone Standard, and it applies to every job, no exceptions.

We also answer the phone. A live person picks up 24/7, not a call tree. When a Taft homeowner has a failed seal or a window that won’t close against the afternoon thunderstorm, they don’t want a callback form. They want a voice. Ours is always there.

Our Window Replacement Services in Taft

Full Frame Replacement

Full-frame replacement in Taft means removing the existing window down to the rough opening: frame, sill, trim, and all. On Taft’s older CBS homes, that’s often where the real problems surface. We find rotted wood surrounds from years of wind-driven rain, block cavities that have been wicking moisture for decades, and openings that were never properly sealed when the house was built. We rebuild the opening, flash it correctly, set the new frame square and plumb, and trim it out so it sheds water the way it should. Full-frame is the right call when the jamb is compromised or when code requires a U-factor that a retrofit insert can’t hit.

Insert Window Replacement

An insert, or retrofit pocket window, fits into the existing frame when that frame is still sound. For many Taft homes, this is the most cost-effective path. The original aluminum track gets replaced with a new fusion-welded vinyl or aluminum unit carrying low-E glass and argon fill, and the job can often be done in a single visit. We measure every opening twice before ordering, so the insert seats cleanly the first time. If we open the wall and find rot or a bowing frame, we stop and show you before proceeding. No surprises, no change orders slipped in after the fact.

Storm Window Replacement

Taft sits through a June-through-September storm season that brings wind-driven rain nearly every afternoon. A storm window that rattles, leaks, or no longer latches is a signal the opening needs more than a stopgap. We replace storm units with impact-rated or high-DP-rated glass where the home’s exposure warrants it, and we tie the new frame into the existing weather barrier so water stays outside the block wall. For homes directly under the Orlando International Airport approach, we also run acoustic calculations so the replacement window handles both storm noise and jet noise.

Energy-Efficient Upgrade

Single-pane aluminum windows are thermal sieves. In Taft’s climate, they dump solar heat into the house from April through October and bleed cooled air out all year. Upgrading to low-E insulated glass with argon fill typically cuts solar heat gain by 40% or more, and on a 1,500-square-foot CBS home that translates directly to a lower electric bill. We quote manufacturer lines side by side on paper, so you see the exact U-factor and SHGC of each option before you buy. Orange County enforces Florida Energy Code on every permitted replacement, so we do the permit paperwork and the compliance check as part of the job.

Trusted Brands We Service in Taft

TruePane is an authorized installer for more than a dozen manufacturer lines, and for Taft homes we frequently recommend, PGT, and CGI depending on what the opening is up against. Simonton’s double-hung and casement units hold up well in the humid subtropics and carry a strong warranty when registered properly. PGT and CGI are the go-to choices for impact-rated openings, and CGI’s laminated glass also does meaningful work cutting airport noise. We stock common parts locally for Taft customers, so warranty service calls don’t wait on a distributor two counties away.

Common Window Replacement Problems We See in Taft Homes

• Jalousie windows still in service. These louvered glass units were a post-war Florida staple, and Taft still has plenty of them. They cannot be retrofitted to meet current Florida Energy Code U-factor requirements, so Orange County will not pass a repair. Full replacement is the only legal path.
• Single-pane aluminum sliders leaking wind-driven rain. The original sliders on 1950s and 1960s CBS blocks have no thermal break and no meaningful seal against a summer squall. Water gets into the block cavity, rots the wood surround, and drives cooling loads through the roof.
• Fogged insulated glass from seal failure. We see a second replacement cycle in Taft that neighboring cities don’t. Homeowners who put in standard double-pane units during the 1990s are finding the seals failed under airport vibration and humidity swings. The glass fogs, the noise comes back, and they’re upgrading again, this time to laminated acoustic glass.
• Failed flashing at the sill. On older Taft blocks, the original flashing was often just a bead of caulk. Forty years of UV and storm water later, the sill rots, the window drops, and the opening starts pulling away from the block. We strip it down, reset the flashing with modern tape and pan systems, and give the new unit a true drainage path.

Pricing for Window Replacement in Taft, FL

We Also Serve Cities Near Taft

Our crews work Taft regularly, and we also serve homeowners in Window Replacement projects across Acacia Villas, Alafaya, Altamonte Springs, and Altoona. If you’re just outside town and need the same level of accountability, call (813) 320-9346 and ask. For a full look at what we do, see our Window Replacement in Taft service area details.

FAQs - Window Replacement in Taft