Free in-home measure and quote - PGT, CGI and CWS impact lines compared on your actual openings, style by style
Sliding glass doors
Impact garage doorsPGTCGI
Before
After
Before
After
Before
AfterTrusted Door Installation for Tampa Homeowners
A properly installed door in Tampa does more than open and close. It seals against the humidity that swells wood frames in Hyde Park, stands square when the afternoon thunderstorms roll through Seminole Heights, and locks tight against the kind of wind gusts that rattle cheap hardware loose in Westchase. Door installation in Tampa costs between $250 and $4,500 depending on the door type, material, and whether the rough opening needs reframing. Most standard entry door replacements run $800 to $2,200 installed.
TruePane Windows & Doors has installed, replaced, and serviced doors for Tampa homeowners since 2008. Dale Kessler founded this company in 2008 on a rule that still governs every job: if the pane is not true, the job is not done. That applies to the glass in a French door, the swing of an entry door, and the track on a bifold. We are not the cheapest bid in town, and we don’t try to be. We are the last call you make for a door that operates the way it should – square, sealed, and done right the first time. Call (813) 320-9346 and a live person answers, day or night.
What Our Door Installation Service Includes
Entry & Swing Doors
An entry door takes more abuse than any other opening in a Tampa home. Sun, rain, humidity, and daily use work against the hinges, the threshold, and the weatherstripping. We install steel, fiberglass, and wood entry doors with full frame replacement or door-slab-only swaps, depending on what the existing jamb will support. Every entry door gets a level check on all four corners, a reveal check along the latch side, and a sweep adjustment that keeps the afternoon rain outside where it belongs.
Double & French Doors
Double doors fail when one panel drifts out of alignment and the astragal no longer meets. In Tampa, the seasonal shift between dry winter air and wet summer humidity makes this worse. We install double doors as matched pairs, shim the hinge side to carry the weight evenly, and adjust the active leaf and astragal so both panels close flush without binding. French doors get the same treatment plus a close look at the glass seals, because a fogged French door in Tampa is a sign the insulated unit has already started to fail.
Bifold & Folding Doors
Bifold doors give you a wide opening without the swing clearance a French door needs. They are common on laundry rooms, pantries, and patio openings throughout Tampa. The problem is usually the track or the pivot hardware, and a door that binds halfway open is telling you the top track has sagged or the bottom pivot is worn. We install bifold systems with the header reinforced and the pivot points set so the panels glide without scraping, whether it is a two-panel closet door or a multi-panel patio folding system.
Pivot Doors
A pivot door carries its weight on a top and bottom pivot hinge instead of side hinges, which means a heavier door can swing with less stress on the frame. Tampa homeowners choose pivot doors for modern entryways, and they demand a different installation discipline. The door has to hang perfectly plumb in both planes, or the gap along the pivot side opens and closes as the door swings. TruePane technicians measure the opening twice, set the pivot plates with a laser, and test the swing before the hardware gets its final torque.
Storm Doors
A storm door in Tampa is a second line of defense against rain, bugs, and wind, and it also protects the entry door from direct sun exposure that fades finishes and dries out seals. We install storm doors with the closer tension set for the homeowner’s preference, the bottom sweep trimmed to clear the threshold, and the latch adjusted so it clicks without slamming. Because Tampa sees real wind, we anchor the storm door frame into the brick or siding with hardware that will not pull loose after a season of thunderstorms.
Arched & Custom Doors
Arched openings and custom door shapes require more than a stock unit and a box of shims. The rough opening has to be measured point by point, and the door has to be cut or ordered to match the radius of the arch. TruePane has built and installed arched doors for some of the older homes in Tampa Heights and Palma Ceia, where no two openings are identical. We template the opening, order the door to match, and set it so the reveal follows the arch evenly from hinge to latch.
What happens when you call
- 1
A real person answersNo phone trees - you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Brands We Service for Door Installation
We install Anderson doors and walk through the warranty registration with the homeowner before the truck leaves the driveway. That includes the finish warranty and the hardware warranty, both in writing, with the durations stated. A door warranty that is not registered is a door warranty that will not pay out when you need it, and we have seen too many Tampa homeowners learn that after the fact.
We also install and service ES Windows door systems, including their sliding and folding patio door lines. These are heavier units that require precise track installation and level mounting, and our technicians have the training and the equipment to set them correctly. PGT doors show up on a lot of Tampa homes because they are built for Florida wind loads, and we install them to the manufacturer’s published specifications. Whether you have one of these brands or any other make, we can quote it side by side on paper so you see exactly what you are buying.
Signs You Need Door Installation Right Now
- The door sticks or binds in summer. Tampa humidity swells wood doors and frames, and a door that rubs against the jamb in July is telling you the reveal was never right or the frame has moved. Left alone, the door scrapes the finish off and the binding gets worse until the latch no longer aligns.
- You can see daylight around the closed door. A gap at the threshold or along the latch side means the weatherstripping is not sealing, and that gap lets conditioned air out and hot, humid air in. Your electric bill notices before you do, especially in July and August when the AC runs all day.
- The door will not lock without lifting or pulling on it. When the latch and strike plate drift out of line, the lock is the first casualty. A door that will not lock is a security problem, and a door that needs a shoulder against it is a frame problem that shims alone will not fix.
- Water stains on the floor or the wall near the door. A leaking door threshold or a failed door seal lets rain from Tampa thunderstorms run inside, and the damage shows up as staining on the baseboard, warped flooring, or drywall that feels soft to the touch. By the time you see the stain, the water has been getting in for a while.
- The door panel has a crack, a split, or a rotted bottom rail. Florida sun and rain work on exterior doors from both sides, and wood doors in Tampa rot at the bottom rail first. Once the wood starts to go, the door loses structural strength, the hinge screws lose their bite, and the whole opening needs inspection rather than a putty patch.
Our Door Installation Process - Step by Step
- 1
The measure and the conversation. We measure every opening twice, with a tape and a level, before we ever talk about a door. We look at the existing frame, the threshold, the floor underneath, and the way the current door operates. Then we quote manufacturer lines side by side on paper so you can compare what you are actually buying, not what a salesman wants you to buy.
- 2
The written quote. The price we give you is the price you pay. No surprise line items on the bill, no change orders because we found a problem we should have caught at the measure. The written quote includes the door, the hardware, the installation, and any reframing the opening needs.
- 3
Removal and rough opening inspection. When we take out the old door, we look at what is behind it. Rotted framing, missing flashing, a threshold that has been leaking for years – any of it gets addressed before the new door goes in. We will not set a new door in a bad opening and call the job done.
- 4
Installation and adjustment. The door gets set level and plumb, shimmed at the hinges and the latch, and screwed into the framing, not just the trim. We check the reveal all the way around, adjust the sweep and the weatherstripping, and tighten the hardware to spec. A level sits on the door at the end, and if the bubble is not centered, the door is not finished.
- 5
Warranty registration and the walkthrough. Before the truck leaves the driveway, both manufacturer warranty layers are registered in writing, with the durations stated. We walk you through the door, show you how the hardware works, and leave you with a copy of everything. If something is not right within 90 days, we make it right. No paperwork fights, no arguing.
How Much Does Door Installation Cost in Tampa?
A standard entry door replacement in Tampa runs $800 to $2,200 installed for a steel or fiberglass door with standard hardware. Double French door installations typically run $2,000 to $4,500 depending on the size, the glass package, and whether the rough opening needs reframing. Storm doors run $400 to $1,200 installed. Custom arched or pivot doors are quoted per job, because the opening drives the price more than the door does.
What affects the price: the condition of the rough opening, whether the existing frame is square and solid, the door material and glass package, the hardware grade, and whether the job is a slab swap or a full frame replacement. Full frame replacement costs more because it includes new jambs, brickmold, and exterior trim, but it is the right call when the old frame has rotted or shifted.
The way to avoid overpaying is to get a written quote that itemizes the door, the hardware, the installation, and any reframing. A door quote that just says “installed” does not tell you what you are paying for. Our free estimate includes all of it, line by line, with both warranty layers registered before we leave. Call (813) 320-9346 for an exact quote on your opening.
Door Installation Near Tampa - Our Service Area
TruePane Windows & Doors installs doors throughout Tampa and the surrounding communities, including Door Installation in Altamonte Springs, Door Installation in Alafaya, and Door Installation in Acacia Villas. We serve homeowners from Apollo Beach to Lutz, and from Ybor City to Westchase. Our home base is right here in Tampa, and we are not routing trucks from Orlando or a regional call center. When you call (813) 320-9346, you are talking to someone local who knows the streets, the neighborhoods, and the way Florida weather treats a door.
Serving Tampa, FL - Our Local Coverage Area
We’re based in the Tampa area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
Frequently Asked Questions - Door Installation in Tampa
Door installation is the full process of removing an existing door and setting a new one in its place, including the frame, hardware, weatherstripping, and trim where needed. In Tampa, proper door installation also means accounting for humidity, heavy rain, and wind loads that affect how a door and its seals perform over time. A door that is installed out of square will bind, leak, and wear out its hardware years early. We install every door – from an Acacia Villas entry replacement to a Alafaya patio slider – level, plumb, and true.
Most single entry door installations are completed in half a day to a full day. A standard slab swap, where the existing frame is sound and we reuse it, can be done in a few hours. A full frame replacement, or a double French door with reframing, typically takes a full day, and custom or arched installations may run longer depending on the opening. We will tell you upfront how long your specific job takes, and we will be there when we say.
Most door installation in Tampa runs $250 to $4,500 depending on the door type, material, and scope of work. Entry door replacements are generally $800 to $2,200, storm doors $400 to $1,200, and double French doors $2,000 to $4,500. The exact price depends on the condition of the rough opening, the door line you choose, and the hardware grade. Call (813) 320-9346 for a free written estimate, and you will see every line item before you commit to anything.
Yes, we are an authorized installer for more than a dozen manufacturer lines, including Andersen and PGT, and we install and service their doors throughout Tampa. We also work with ES Windows, Marvin, Pella, CGI, and other major brands. If you have a door that is still under manufacturer warranty, we handle the warranty registration and the service work so the warranty stays intact. Give us a call at (813) 320-9346 and tell us what you have; we will tell you what we can do.
If you have a door that will not close, will not lock, or has been damaged by a storm or a break-in, call (813) 320-9346. A live person answers 24 hours a day, 7 days a week, and we will get someone out to secure your home and talk through the next step. We keep common entry door hardware and basic door sizes on the truck, so many emergency repairs can be handled the same day. The goal is to get your home secure and the door operating, and we will not leave you hanging overnight.
Every door installation comes with the 90-Day Done Right Promise and the Keystone Standard. That means both manufacturer warranty layers are registered in writing, with the durations stated, before the truck leaves the driveway. If something is not done right within 90 days, we make it right at no cost – no paperwork fights, no arguing. Beyond the 90 days, the manufacturer warranties cover the door materials and components per their terms, and we handle the service work if something fails.
Clear the area around the door inside and out, including any furniture, rugs, or decor within about six feet of the opening. If you have pets, keep them secured in another room while we work. We will lay down drop cloths to protect the floors, and we clean up the work area before we leave. Beyond that, there is nothing you need to do – we bring the tools, the hardware, and the replacement trim, and we take the old door with us when we leave. Call (813) 320-9346 if you have any questions before the installation day.
Schedule Your Door Installation Service in Tampa Today
A door that binds, leaks, or will not lock is not going to fix itself, and Tampa weather will keep working on it until it is fixed. Call TruePane Windows & Doors at (813) 320-9346 for a free, no-obligation estimate. A live person answers, we measure twice, and we write the quote line by line so you know exactly what you are paying. If the pane is not true, the job is not done – and that is the way we have done it since 2008 in Tampa.
Written by Dale Kessler, Owner at TruePane Windows & Doors, serving Tampa since 2008.
Six Reasons Homeowners Choose TruePane Windows & Doors
Impact systems engineered to design pressures up to +/-100, matched to your wind zone - your openings hold when the storm arrives.
Low-E insulated impact glass from our manufacturer lines commonly cuts monthly cooling bills 20-30%.
Laminated impact glass shuts out up to 40% of outside noise - traffic, neighbors, weather.
Monitoring services run $30-90 a month. Laminated impact glass resists forced entry around the clock, with no subscription.
Florida homeowners average around 25% savings on the windstorm portion of their policy after protecting every opening - some homes qualify for more.
A full impact package upgrades curb appeal, buyer confidence and appraised value in one project.